Harddrive disconnects and reconnects
Posted: Sun Jun 02, 2024 9:00 pm
I have a 2TB HDD which I pulled from an external enclosure. Anytime I try to create an image of the drive, It starts to disconnect after about 5 minutes. It will then reconnect immediately, but this stalls the recovery process.
Are there any settings I can use in order to make this work?
I'm using the Deepspar Stabilizer and running 9.4 on windows 11.
The FS of the drive is Apple HSFX. Is that a problem? There are no weird noises and the only SMART issue is:
Health Status: CAUTION
Temperature: 30 °C
Power on Hours: 620 hour
Power on Count: 553 count
Rotation Rate: 5400 RPM
Standard: ATA8-ACS | ATA8-ACS version 6
Features: S.M.A.R.T., APM, AAM, 48bit LBA, NCQ
Caution C5 Current Pending Sector Count 100 100 0 0000000000D8
Thank you
Are there any settings I can use in order to make this work?
I'm using the Deepspar Stabilizer and running 9.4 on windows 11.
The FS of the drive is Apple HSFX. Is that a problem? There are no weird noises and the only SMART issue is:
Health Status: CAUTION
Temperature: 30 °C
Power on Hours: 620 hour
Power on Count: 553 count
Rotation Rate: 5400 RPM
Standard: ATA8-ACS | ATA8-ACS version 6
Features: S.M.A.R.T., APM, AAM, 48bit LBA, NCQ
Caution C5 Current Pending Sector Count 100 100 0 0000000000D8 Thank you