rebuilding windows software RAID 0 stripe
Posted: Mon May 03, 2010 4:38 pm
I have a windows software RAID 0 stripe set containing 2 disks. Windows has lost track of the stripe set and now sees the two disks as seperate as opposed to belonging to single stripe set.
When I Build a Virtual Block RAID, and add my two disks using the default block size of 64KB, and 0 offset, and do a partial scan it reveals the directory structure on the disk. Does this mean that the RAID parameters are correct? I have been told that Windows typically uses an offset of 63 and a block size of 16 for software stripe sets.
Thanks in Advance!
best-
-Nat
When I Build a Virtual Block RAID, and add my two disks using the default block size of 64KB, and 0 offset, and do a partial scan it reveals the directory structure on the disk. Does this mean that the RAID parameters are correct? I have been told that Windows typically uses an offset of 63 and a block size of 16 for software stripe sets.
Thanks in Advance!
best-
-Nat