Performance
Posted: Wed Feb 22, 2012 5:08 pm
So, I'm pulling data off an HFS drive that's attached to an enclosure hanging off a usb port on my laptop.
As I sit here and gaze morosely at the progress bar, it dawns on me that I could have used esata.
This didn't occur to me until I was about halfway through the scan, so I'm just letting it run.
How much difference would the connection make during the scan?
I did not take the option to save the scan to a file - will I have an option to do this at the end of the scan?
Will I be able to then switch to esata, load the saved scan, and proceed with recovery?
As I sit here and gaze morosely at the progress bar, it dawns on me that I could have used esata.
This didn't occur to me until I was about halfway through the scan, so I'm just letting it run.
How much difference would the connection make during the scan?
I did not take the option to save the scan to a file - will I have an option to do this at the end of the scan?
Will I be able to then switch to esata, load the saved scan, and proceed with recovery?