WD My Passport
Posted: Tue Jul 23, 2013 6:26 pm
I am trying to recover files from a WD My Passport 500GB drive. When I hook it up it does ID the drive, but I get the error "Read disk WDMy Passport at_____failed after 1 attempt. Media is write protected(19)
I also tried to do a byte by byte image, but it thinks its a 1 TB drive, so it is looking for adequate space. If I imaged it to a 1TB drive would that work? Or is this a firmware error that can not be overcome with R-Studio?
Thanks in advance for anyone with knowledge on this.
I also tried to do a byte by byte image, but it thinks its a 1 TB drive, so it is looking for adequate space. If I imaged it to a 1TB drive would that work? Or is this a firmware error that can not be overcome with R-Studio?
Thanks in advance for anyone with knowledge on this.