data recovery failure?
Posted: Wed Feb 01, 2017 2:42 pm
Hi,
I just completed a disk recovery using RStudio 8.2
Everything looked good. The data I was looking for seemed to be there, file names, file extensions, and file sizes were accurate, etc.
However, when trying to open a recovered file, Windows says that the file is damaged, corrupted, or too large.
Is this a symptom of data that is not recoverable, or did I perhaps do something wrong in my data recovery process.
I scanned the disk, browsed through the "Recognized" categories, and found the data that I wanted to recover. Did I perform this process incorrectly, am I missing a step, or is the data lost for good?
If any other additional information is needed, I'd be happy to provide that.
Thanks.
I just completed a disk recovery using RStudio 8.2
Everything looked good. The data I was looking for seemed to be there, file names, file extensions, and file sizes were accurate, etc.
However, when trying to open a recovered file, Windows says that the file is damaged, corrupted, or too large.
Is this a symptom of data that is not recoverable, or did I perhaps do something wrong in my data recovery process.
I scanned the disk, browsed through the "Recognized" categories, and found the data that I wanted to recover. Did I perform this process incorrectly, am I missing a step, or is the data lost for good?
If any other additional information is needed, I'd be happy to provide that.
Thanks.