v4.4 build 4402 not able to access image file

Disk backup and restore, partition imaging and cloning, and drive copy using R-Drive Image.
Forum rules
Discussion on the R-Drive Image software
V

v4.4 build 4402 not able to access image file

Post by V » Wed Dec 24, 2008 5:19 am

I am new to R-Drive Image but I believe there is a problem with the newest version. I created an image file using R-Linux but am not able to load or verify the image with R-Drive Image v4.4 build 4402. The interface for "Restore from an Image", "Check an Image", or "Connect an Image as a Virtual Logical Disk" all do not allow you to go farther than the image selection screen. I am able to browse and find the image file but no matter what I do, the "Next" button does not become active. Is a previoud version or build available so I can finish this task and evaulate the software?
thanks.

Alt
Site Moderator
Posts: 3129
Joined: Tue Nov 11, 2008 2:13 pm
Contact:

Re: v4.4 build 4402 not able to access image file

Post by Alt » Thu Dec 25, 2008 4:33 pm

Did you select "R-Drive Image compatibe" image type on the Create Image dialog box?

Post Reply