Copy DISK to DISK

Disk backup and restore, partition imaging and cloning, and drive copy using R-Drive Image.
Forum rules
Discussion on the R-Drive Image software
CLages1

Copy DISK to DISK

Post by CLages1 » Sun Apr 14, 2013 5:36 pm

Hi, in the past i have cloned my HD (6 months ago)
Now i am trying to clone again, with no sucessfull
The program says everything is fine, finish ok
but when i Get the cloned HD to boot, in get the boot message. NO system Disk.

using Windows manage Disk i can see in the HD (disk 0) all volumes names
but in the Cloned HD i see NO volume name, i see Unformatted

the question is, since i CLONED the entire HD, in the end i supose to see exacty the same HD(partiotion, volume name, etc)
but i can not see this.
i can provide with screen shot
tks
Carlos Lages

Alt
Site Moderator
Posts: 3129
Joined: Tue Nov 11, 2008 2:13 pm
Contact:

Re: Copy DISK to DISK

Post by Alt » Mon Apr 15, 2013 1:46 am

Do you restore the cloned data to the disk which you had cloned or to another one? And if to another one, which method do you select on the Restore/Copy Parameters panel?

Post Reply