Page 1 of 1


Posted: Sun Apr 14, 2013 5:36 pm
by CLages1
Hi, in the past i have cloned my HD (6 months ago)
Now i am trying to clone again, with no sucessfull
The program says everything is fine, finish ok
but when i Get the cloned HD to boot, in get the boot message. NO system Disk.

using Windows manage Disk i can see in the HD (disk 0) all volumes names
but in the Cloned HD i see NO volume name, i see Unformatted

the question is, since i CLONED the entire HD, in the end i supose to see exacty the same HD(partiotion, volume name, etc)
but i can not see this.
i can provide with screen shot
Carlos Lages

Re: Copy DISK to DISK

Posted: Mon Apr 15, 2013 1:46 am
by Alt
Do you restore the cloned data to the disk which you had cloned or to another one? And if to another one, which method do you select on the Restore/Copy Parameters panel?