Disk backup and restore, partition imaging and cloning, and drive copy using R-Drive Image.
Discussion on the R-Drive Image software
- Posts: 8
- Joined: Fri Apr 01, 2011 9:42 pm
I just upgraded to build 6205. When I perform a scripted backup I see the following message:
buffer alignment was changed 4 => 4096 for drive c:
What does this mean? I did not see this message in build 6004.
- Site Moderator
- Posts: 2481
- Joined: Tue Nov 11, 2008 2:13 pm
This message means that while reading from the hard drive the calculated alignment is 4B, but the real one should be 4096.
No actions is required.