RAID0 Recovering accidentally deleted files using R-studio 5.2
Posted: Fri Jul 16, 2021 2:03 pm
Hello,
I had a user delete 1.5TB of data on accident on a Win7 64-bit legacy system, they deleted an entire drive setup in RAID0. I'm currently using R-studio 5.2 to try to recover the files.
Started the recovery task, but it seems to be stuck at 0% for the last hour. I'm not sure if is supposed to take this long or if I'm doing anything wrong. I don't see any recovered data in the set output folder as well.
I'm unable to stop the task, and I didn't want to force quit in case it causes any issues with the recovery. Am I able to kill this task without causing any issues?
Enumeration started and completed, still at 0% on file recovery. I noticed that the drive set for output has stopped spinning from being idle so long, so I take it the task hasn't even begun.
Any help would be appreciated
I had a user delete 1.5TB of data on accident on a Win7 64-bit legacy system, they deleted an entire drive setup in RAID0. I'm currently using R-studio 5.2 to try to recover the files.
Started the recovery task, but it seems to be stuck at 0% for the last hour. I'm not sure if is supposed to take this long or if I'm doing anything wrong. I don't see any recovered data in the set output folder as well.
I'm unable to stop the task, and I didn't want to force quit in case it causes any issues with the recovery. Am I able to kill this task without causing any issues?
Enumeration started and completed, still at 0% on file recovery. I noticed that the drive set for output has stopped spinning from being idle so long, so I take it the task hasn't even begun.
Any help would be appreciated