1TB LaCie Big Disk Extreme
Posted: Wed Jan 05, 2011 4:09 pm
Hi - the controller board and one of the hard drive boards died in my LaCie Big Disk Extreme. I made a byte-for-byte disk image of the good drive, then put its controller board on the drive with the bad board, and connected it via a USB SATA adapter.
With R-Studio I am now scanning this former RAID 0 (now comprised of one disk image and one hard drive) for files but I don't know if that will work, and what settings to use. The scan it's doing is going to take 1 day 14 hours. Is there just a way to attempt a re-stripe and then shouldn't the file system still be intact? What settings should I use for this to work most effectively?
Thanks,
Eric
With R-Studio I am now scanning this former RAID 0 (now comprised of one disk image and one hard drive) for files but I don't know if that will work, and what settings to use. The scan it's doing is going to take 1 day 14 hours. Is there just a way to attempt a re-stripe and then shouldn't the file system still be intact? What settings should I use for this to work most effectively?
Thanks,
Eric