RAID 6 recovery scan seems to hang at 99%
Posted: Mon Feb 16, 2015 9:41 pm
I am trying to perform recovery of a 10.7 TB RAID 6 volume from a QNAP file server in another Windows 7 machine. I have built the virtual RAID and the scan seemed to be doing just fine and was chugging along for about 1d18h when I first noticed the "time remaining" kept getting longer, but it was consistently counting down. It got to the last block, 99% complete and a minute remaining and then did something weird - it went to 30% complete and like 8 days remaining...but it seemed to chug pretty quickly (w/in 10 minutes) back to 99%, but it's been pretty much stuck at 4 minutes and some seconds remaining for the last 8+ hours. Any thoughts?
I picked RAID6 / Reed-Solomon, but it was a SWAG (I know it's a RAID 6 volume, but not sure which schema they use)
I am using R-Studio 7.6.156433 on a Windows 7 Dual Xeon machine w/ 4GB of memory and a 3ware 9550SX-8 controller.
NOTE: I never saw Partition 1 show up under the virtual RAID in the drive pain as described/shown in step 3 from http://www.r-tt.com/Articles/RAID_Recov ... ndex.shtml
I picked RAID6 / Reed-Solomon, but it was a SWAG (I know it's a RAID 6 volume, but not sure which schema they use)
I am using R-Studio 7.6.156433 on a Windows 7 Dual Xeon machine w/ 4GB of memory and a 3ware 9550SX-8 controller.
NOTE: I never saw Partition 1 show up under the virtual RAID in the drive pain as described/shown in step 3 from http://www.r-tt.com/Articles/RAID_Recov ... ndex.shtml