Improvements for R-Studio
Posted: Mon Dec 04, 2017 9:06 am
Hi Guys
I had a case here with a Lenovo NAS where after I connect both drives to the PC, using R-studio I needed to create and configure the RAID with all the parameters.
But using UFS explorer, it automatically detected those details and the partition showed immediately without any trouble. I just copied the data out.
I think you could improve this also in R-Studio.
Thanks
I had a case here with a Lenovo NAS where after I connect both drives to the PC, using R-studio I needed to create and configure the RAID with all the parameters.
But using UFS explorer, it automatically detected those details and the partition showed immediately without any trouble. I just copied the data out.
I think you could improve this also in R-Studio.
Thanks