How to tell if disks are RAID 0 or 1 ?
Posted: Wed Feb 07, 2018 1:07 pm
Hello,
I have an old Lacie firewire enclosure (model 300873) that does not mount on any computer that I own. I'm suspicious that the firewire controller is dead so I would like to attempt a recovery using R-studio. I have removed both drives and attached one to a generic USB enclosure. R-studio can see the drive and I am in the middle of creating a bit for bit disk image of the first HD. Is there some way for me to determine if the HDs were configured as RAID 0 or 1 or maybe JBOD?
Thanks.
I have an old Lacie firewire enclosure (model 300873) that does not mount on any computer that I own. I'm suspicious that the firewire controller is dead so I would like to attempt a recovery using R-studio. I have removed both drives and attached one to a generic USB enclosure. R-studio can see the drive and I am in the middle of creating a bit for bit disk image of the first HD. Is there some way for me to determine if the HDs were configured as RAID 0 or 1 or maybe JBOD?
Thanks.