Page 1 of 1

RAID ext3 missing disk from ReadyNAS NV+

Posted: Thu May 24, 2018 1:59 am
by jn441
I had a disk fail on a RAID5, and then simultaneously one of the good remaining disks fell out of the array. Apparently it's a known issue with this model of drive. I confirmed all the disks are good.

I connected all three remaining disks via SATA. I have tried adding the volumes to a new array and getting RStudio to autodetect it (even tried including a "missing disk") but I haven't really had any luck. This is XRAID and ext3

I can see the original c array, but when I open the LVM components tab I can't choose the volume that fell out of the array. I can't figure out how to get this disk back in there.

The dropdown in the middle doesn't let me choose the volume I want:

Image

Re: RAID ext3 missing disk from ReadyNAS NV+

Posted: Thu May 24, 2018 10:23 am
by Alt
We need some more information to investigate the problem. We need the following:
System info: Tools -> Save system info. There will be two files.
A screen shot of the Drives panel, and list of disks that are from the RAID, and the disk that you cannot find in the dropdown menu.
Please zip them and send to raptorbck (at) gmail (dot) com .
This information will not contain any data, only the information about your system hardware and disk partitioning.

Re: RAID ext3 missing disk from ReadyNAS NV+

Posted: Thu May 24, 2018 2:16 pm
by jn441
I have sent that, thank you very much for the reply

Re: RAID ext3 missing disk from ReadyNAS NV+

Posted: Thu May 24, 2018 2:22 pm
by Alt
jn441 wrote:
Thu May 24, 2018 2:16 pm
I have sent that, thank you very much for the reply
We've received it, and I've sent all the data to our developers.

Re: RAID ext3 missing disk from ReadyNAS NV+

Posted: Wed Jun 06, 2018 6:52 pm
by jn441
Is there anything I should try (editing the disk's GUID etc) or should I wait for a developer response

Re: RAID ext3 missing disk from ReadyNAS NV+

Posted: Thu Jun 07, 2018 12:44 pm
by Alt
jn441 wrote:
Wed Jun 06, 2018 6:52 pm
Is there anything I should try (editing the disk's GUID etc) or should I wait for a developer response
I'll ask the developers.