R-Studio recovery problem

A forum on data recovery using the professional data recovery software R-STUDIO.
panth3r

R-Studio recovery problem

Post by panth3r » Sat May 19, 2012 5:27 am

Hi Folks,

I'm using R-Studio to recover from a hard drive problem.
I am creating a drive image to perform recovery from as per your help & FAQs suggest.

It's running, and was going quite well until hitting 91% of the drive, whereupon it seems all sectors are bad and it's unable to read from them.
It's been trying to read from sectors around the 91% mark for over 14 hours now... My question is - If I hit stop on the dialog box, will the image be completed and be usable, or will the whole process be nullified and have to start again? Am I better off leaving it for days and hoping?

Any help appreciated.

Alt
Site Moderator
Posts: 3129
Joined: Tue Nov 11, 2008 2:13 pm
Contact:

Re: R-Studio recovery problem

Post by Alt » Mon May 21, 2012 11:33 am

Unfortunately, the image file will be deleted, so you'll have to wait until the imaging is over.

Post Reply