Hi,
My encrypted partition (by VeraCrypt) was quick formatted by accident. Under veracrypt I restored header of the partition so I'm able to mount and decrypt this partition. It's abviously empty.
I used R-Studio to recover files. I did full scan of the disk and R-Stusio found this partition - unfortunatelly marked as red. All files are visible under R-Studio and marked as green (Good - existing file). But when I try to recover files from the disk in most cases I got this message:
"Can't read file to be recovered completely (801)."
Recovered files are half of the size (ar less) and corruped.
I went through the internet and forum but found no solution.
And... that's the point I need Your help... Does anyone know the solution of this problem (if possible)?
Thank You,
Peter
Error: Can't read file to be recovered (810) on VeraCrypt drive. Solution?
Re: Error: Can't read file to be recovered (810) on VeraCrypt drive. Solution?
I asume that you mounted a VeraCrypt drive and scanned the VeraCrypt virtual drive like how it's described in our article Data Recovery from Various File Container Formats and Encrypted Disks.
If yes, I think some part(s) of the container's file is/are incorrectly decrypted for some reasons.
You may look at the Extra Found Files section to see what happened with raw files.
If yes, I think some part(s) of the container's file is/are incorrectly decrypted for some reasons.
You may look at the Extra Found Files section to see what happened with raw files.
Re: Error: Can't read file to be recovered (810) on VeraCrypt drive. Solution?
Yes. I did it. But as I mentioned - all files are corrupted - usually after recovery they are less than 5kB.
Re: Error: Can't read file to be recovered (810) on VeraCrypt drive. Solution?
What's about files in the Raw Files section? Are there any files that can be recovered successfully?