Page 2 of 2
Re: Recovering Data from a Failed RAID 5
Posted: Wed Mar 26, 2014 1:50 pm
by Alt
If you already have the scan info for the RAID, you don't have to rescan it. Just load it.
R-Studio's on-line help:
Disk Scan. Just set the Size to app. 90% of the RAID size.
Re: Recovering Data from a Failed RAID 5
Posted: Wed Mar 26, 2014 3:05 pm
by mjatalla
Alt, I was experiencing something similar when I was trying to recover my raid 5. If the underlying FS had LVM, could it cause this behavior?
Re: Recovering Data from a Failed RAID 5
Posted: Thu Mar 27, 2014 3:40 am
by Alt
mjatalla wrote:Alt, I was experiencing something similar when I was trying to recover my raid 5. If the underlying FS had LVM, could it cause this behavior?
It's a possibility, R-Studio doesn't support LVM yet.
Re: Recovering Data from a Failed RAID 5
Posted: Thu Mar 27, 2014 7:57 pm
by sdukart
I was able to successfully complete to 100%. Next big question...which version do I buy now? I am restoring to USB drives that are attached to the computer that has R-Studio installed on it.
R-Studio
or
R-Studio Network Edition
Re: Recovering Data from a Failed RAID 5
Posted: Fri Mar 28, 2014 12:05 pm
by Alt
sdukart wrote:I was able to successfully complete to 100%. Next big question...which version do I buy now? I am restoring to USB drives that are attached to the computer that has R-Studio installed on it.
R-Studio
or
R-Studio Network Edition
First and most important, thoroughly test the results by previewing files, and buy R-Studio only if you're satisfied with the results.
Second, I think, R-Studio will be enough.
Re: Recovering Data from a Failed RAID 5
Posted: Fri Mar 28, 2014 7:51 pm
by sdukart
Thank you. I have purchased R-Studio...in process.
Re: Recovering Data from a Failed RAID 5
Posted: Sat Mar 29, 2014 4:02 am
by Alt
Good luck in recovery!