Integrate ddrescue recovery maps

A forum on data recovery using the professional data recovery software R-STUDIO.
elmo

Integrate ddrescue recovery maps

Post by elmo » Sun Aug 04, 2019 4:36 pm

Often, I make an image of a faulty disk using ddrescue and then perform analysis using R-Studio. Is there a way to integrate the ddrescue mapfile into R-Studio so that I could ignore files that haven't been fully recovered (i.e. the mapfile shows read errors for that range of bytes) - maybe via the Recovery Chances mechanism?

Data-Medics
Posts: 190
Joined: Tue Oct 20, 2015 10:13 am
Location: Providence, RI USA
Contact:

Re: Integrate ddrescue recovery maps

Post by Data-Medics » Wed Aug 21, 2019 11:55 am

It's not possible currently, but I wish this was a feature of the Technician version. I'd second the motion to add such map support. That and PC-3000 map support.

Post Reply