Stuck on 100% "analyzing recognized partition layouts"

A forum on data recovery using the professional data recovery software R-STUDIO.
Guest

Stuck on 100% "analyzing recognized partition layouts"

Post by Guest » Tue Sep 13, 2011 12:40 pm

Hi,

this was my 3rd attempt to scan corrupt ntfs partition and for the 3rdtime it has stuck at 100% now for 8hours. Is that normal should I just wait for it to finish?

Alt
Site Moderator
Posts: 2271
Joined: Tue Nov 11, 2008 2:13 pm
Contact:

Re: Stuck on 100% "analyzing recognized partition layouts"

Post by Alt » Tue Sep 13, 2011 1:21 pm

No, this is non normal. Most likely there are some bad sectors in that partitions that may cause the problem. I recommend you to stop scanning and save the scan info, and work with the results. Not much information are on those sectors.
If you cannot stop it within R-Studio, kill it in Task Manager, and repeat the scan, creating a region smaller than the disk. You may read how to create the region in our online help: Regions.

Post Reply