R-Studio for Mac, issues recovering RAID0

A forum on data recovery using the professional data recovery software R-STUDIO.
Post Reply
organisum
Posts: 1
Joined: Sat Mar 08, 2014 4:42 pm

R-Studio for Mac, issues recovering RAID0

Post by organisum » Sat Mar 08, 2014 4:47 pm

I'm recovering a RAID0 volume. First created with Apple's Disk Utility, then inadvertently deleted the RAID with Disk Utility. But not touching the drives after deleting the RAID.

I've created a virtual RAID but when recovering the data about 300 GB in, I get error messages stating it is Unable to generate a RAID checksum and it can't regenerate RAID5 parity.

Why does this show up for a RAID0 set? I could have used one of the disks in a RAID5 previously, but I don't think so.
Top
Alt
Site Moderator
Posts: 3240
Joined: Tue Nov 11, 2008 2:13 pm
Contact:
Contact Alt

Re: R-Studio for Mac, issues recovering RAID0

Post by Alt » Sun Mar 09, 2014 1:03 pm

Can I see the screenshots of the Drives panel and Parents tab?
Top
Post Reply

Return to “File Recovery”