Re: NAS RAID5 recovery
Posted: Thu Sep 26, 2013 6:30 am
They should work, at least as far as they're used in R-Studio.
Data Recovery and Disk Utilities Forum @R-TT
A place to discuss data recovery, data backup and other software developed by R-TT Inc.
https://forum.r-tt.com/
NAS RAID5 recovery
Page 2 of 2
Re: NAS RAID5 recovery
Posted: Thu Sep 26, 2013 5:35 pm
Great - thanks - just using the autodetect for RAID now - 60%, then will start recovery again. Thanks for all you help so far, much appreciated.
Re: NAS RAID5 recovery
Posted: Fri Oct 04, 2013 1:19 am
Been using the autodetect option to identify my RAID parameters.
Had to start again following a VPN issue, so clicked on Autodetect. The percentage bar went up from 0 to 55% pretty quickly, then slowed right down - getting about 1% every 40 hours.
Log
11:42 02/10/13 - Caculate RAID Offsets started
It's now 15:48 05/10/13 and states 18.06mb processed 61% detection rate - its been like that for about 10 hours now.
Had to start again following a VPN issue, so clicked on Autodetect. The percentage bar went up from 0 to 55% pretty quickly, then slowed right down - getting about 1% every 40 hours.
Log
11:42 02/10/13 - Caculate RAID Offsets started
It's now 15:48 05/10/13 and states 18.06mb processed 61% detection rate - its been like that for about 10 hours now.
Re: NAS RAID5 recovery
Posted: Fri Oct 04, 2013 10:52 am
You may stop RAID parameter detection and see what R-Studio has found.
Re: NAS RAID5 recovery
Posted: Sat Oct 05, 2013 2:14 am
Just checked progress - now up to 71% - increase of 10% in 24 hours. Must admit I'm nervous about stopping it. So I may leave it another 24 hours and see 
Re: NAS RAID5 recovery
Posted: Sun Oct 06, 2013 10:44 pm
Got up to 73% and crashed - I've sent the report to support, though it looks like the application ran out of memory (12Gb RAM installed). Should have stopped it as per your previous post - oh well, lets start again.... 