Data Recovery and Disk Utilities Forum @R-TT

Got up to 73% and crashed - I've sent the report to support, though it looks like the application ran out of memory (12Gb RAM installed). Should have stopped it as per your previous post - oh well, lets start again....

Just checked progress - now up to 71% - increase of 10% in 24 hours. Must admit I'm nervous about stopping it. So I may leave it another 24 hours and see

You may stop RAID parameter detection and see what R-Studio has found.

Been using the autodetect option to identify my RAID parameters.

Had to start again following a VPN issue, so clicked on Autodetect. The percentage bar went up from 0 to 55% pretty quickly, then slowed right down - getting about 1% every 40 hours.

Log
11:42 02/10/13 - Caculate RAID Offsets started

It's now 15:48 05/10/13 and states 18.06mb processed 61% detection rate - its been like that for about 10 hours now.

Great - thanks - just using the autodetect for RAID now - 60%, then will start recovery again. Thanks for all you help so far, much appreciated.

They should work, at least as far as they're used in R-Studio.

Thanks downloaded. Quick question, I imaged the 5x 2TB drives using R-Studio compressed image. Though someone at work tells me that the compressed image will not work. The only problem is I don't have 10Tb free to do a byte-to-byte image. So will I be able to recover from compressed images?

Try our new version of R-Studio, it can find RAID parameters automatically. At least, the RAID offset.

Alas no - still attempting recovery.

@ nasz: have you solved the issue?

Cor