Integrate ddrescue recovery maps

A forum on data recovery using the professional data recovery software R-STUDIO.
elmo

Integrate ddrescue recovery maps

Post by elmo » Sun Aug 04, 2019 4:36 pm

Often, I make an image of a faulty disk using ddrescue and then perform analysis using R-Studio. Is there a way to integrate the ddrescue mapfile into R-Studio so that I could ignore files that haven't been fully recovered (i.e. the mapfile shows read errors for that range of bytes) - maybe via the Recovery Chances mechanism?

Data-Medics
Posts: 194
Joined: Tue Oct 20, 2015 10:13 am
Location: Providence, RI USA
Contact:

Re: Integrate ddrescue recovery maps

Post by Data-Medics » Wed Aug 21, 2019 11:55 am

It's not possible currently, but I wish this was a feature of the Technician version. I'd second the motion to add such map support. That and PC-3000 map support.

RForce
Posts: 48
Joined: Wed Jul 09, 2014 9:05 am

Re: Integrate ddrescue recovery maps

Post by RForce » Tue Aug 27, 2019 7:43 am

They have supported DDI map files for a few years and still haven't added any way to filter out good/damaged files based on the map. It will show on the interface if the file is imaged or not and even shows the number of unread sectors...but nothing more. It seems that UFS Explorer is working in that direction and will likely give us the features we are looking for sooner than later.

Post Reply