Nothing happens after running a script

Disk backup and restore, partition imaging and cloning, and drive copy using R-Drive Image.
Forum rules
Discussion on the R-Drive Image software
Posts: 53
Joined: Fri Jan 30, 2009 12:11 pm

Re: Nothing happens after running a script

Post by MerleOne » Tue Dec 29, 2020 11:25 am

Maybe stating the obvious but to be fine with script in .rdi format there is a trick I perform : I force r-driveimagecl.exe (in the install folder) to run each time with admin priv. To do this, goto the folder where it is, right-click on the file, select properties, go to compatibility, go to admin button to force this exe to run in admin mode for every user.
Only then can rdi script work on my system.
A workaround is to use a .cmd script like
start "" r-driveimagecl.exe ....
and then launch the .cmd in admin mode. On my PC, .rdi cannot be launched in admin mode.
Not sure it is the issue here but worth trying IMHO

Post Reply