Destination disk is too small

Disk backup and restore, partition imaging and cloning, and drive copy using R-Drive Image.
Forum rules
Discussion on the R-Drive Image software
Post Reply
Hole
Posts: 1
Joined: Fri Nov 11, 2011 11:32 am

Destination disk is too small

Post by Hole » Fri Nov 11, 2011 11:43 am

I have a CompactFlash that contains the bootable OS of a PLC.

I've managed to create an image, and restore it to the CF-card, but I'd also like to have a hardware copy of this card. Therefore I bought a new card.
The problem is that the old card is 1.95GB, and the new is 1.90GB.

I've tried to use both "Sector by sector backup", and "Backup actual data only". The actual data on the card is about 700MB.

Is there a way to make this work?
Top
Alt
Site Moderator
Posts: 3298
Joined: Tue Nov 11, 2008 2:13 pm
Contact:
Contact Alt

Re: Destination disk is too small

Post by Alt » Sat Nov 12, 2011 6:15 am

When you restore data, did you try to adjust the partition size on the Restore/Copy Parameters panel?
Top
Post Reply

Return to “Disk Imaging”