Data Recovery and Disk Utilities Forum @R-TT

Hi,

how would I configure a block raid in rstudio to construct this raid:
http://graphics.adaptec.com/us/TT_SA/R6-X.GIF

best regards
Christian

thank you for the quick reply.

how do i determine the number of lines necessary ? i read the manual but couldnt find a reference to number of lines..
it is determined by block size or disk size or something else ?
i have 5 1 tb drives with 512 kb blocks.

Hi,

ok I have connected all disks to a sata controller, so I can see all disks. I can also see the data on the which seems to be intact. I can see for example partial jpg images where parts are missing. I can also see the directory structure.

I know that the stripe size was 512 kb, but for some ...

Well, I added 4 gb, so its 8 gb ram and installed win 7 x64. it took 11:37 hours to scan my drive.

I did the same scan before asking here with 4 GB ram and win 7 x86 and it took 10:03 hours for the exact same scan.

Hi,

I am kind of lost. I had an adaptec 3805 raid 5 with 4 disks. I accidentally deleted the good array, so all disks are operational. I know the disk order, at least i know which cable / channel went to which disk.
Boot disk was separate plain sata, so no boot from array.

I am trying to rebuild ...

Hi,

its a 4 x 1tb raid 5 so the gpt partition is 2.7 TB. I guess it was more than 1 million files...

Hello,

i have read that for large disks, more ram is useful to speed up scanning and recovery.

Could you post some recommendations ?

I am using r-studio x64 with 4 gb of ram. during the scanning procedure r-studio only uses 120 mb as per task manager.

are there any suggestions as to how much ...

Hi,

I just installed r-studio x64 demo on my 64 bit os.

It installed itself into the x86 folder and in the about box or anywhere is no mention of the x64 version.

Is there any way to verify if its the x64 version or did I get the wrong download ?

cheers
bubba

Hi,

I have a raid 5 GPT on an adaptec 3805. they array is lost... good that I had my data on a raid 5 to prevent loss...

The disk / disks are not listed in r-studio.

any suggestions / workarounds ? Is support for adaptec raid controllers planned ?

Should i connect the disks to the standard sata ...